0086-571-88220973 / 88220971 [e-post beskerme]
0 Items

Tekstynformaasje beskoattelje

Locking Assemblies

Foto en diagram Tekstynformaasje beskoattelje
450-searje
Locking Assemblies technical information ensdia
Rektor
The locking together of two components is achieved by tightening one conical ring against another. The outer ring will have the tendency to enlarge, and start to press against the housing wall, whilst the inner will start to force itself against the shaft.
Oankeppelje
Carefully clean the elements involved, and apply a light film of oil to the surfaces which will be in contact. Fit the assembly into the space in the hub, then insert the shaft through the centre. Gradually tighten the screws and uniformly increase the torque until the Torque level Ta, shown in the tables, is achieved. The figures for T and Fax in these tables are calculated assuming the assembly is done in this way ? using oil.
omtinken
Nea brûke Molybdenum disulphide (MoS2) based oils or greases, they will cause considerable reductions in the friction torque.
Fergrieme
Remove the screws and re-insert them in the extraction holes, increasing the torque gradually once more until the cones separate. In case of re-use after removal, re-oil the screws and threads once more.
Tolerânsje: Undergrûnskwaliteit
A reasonably good machine tool finish is sufficient..
Minimale oerflakkwaliteit fan Rt max 16µm
Maksimum tastiene tolerânsje: Shaft h8, bore H8
Photos Tekstynformaasje beskoattelje
100-searje
Locking Assemblies technical information KTR250
250-searje
Montage yn searje
  • It is possible to mount the locking kits (RTT and RTL) in series.
  • The increase in torque which will be obtained is as follows :
    RTT-RTL
    1 Slotkit, TNm = Kataloguswearde
    2 Slotkit, TNm = Kataloguswearde
    3 Slotkit, TNm = Kataloguswearde
    4 Slotkit, TNm = Kataloguswearde
    x 1,00
    x 1,90
    x 2,70
    x 3,60
  • If several locking assemblies are mounted in series, pay attention to the external diameter of the hub.

 

TAG's:

Pin It on Pinterest